|
Geothermal electricity is electricity generated by geothermal energy. Technologies in use include dry steam power stations, flash steam power stations and binary cycle power stations. Geothermal electricity generation is currently used in 24 countries,〔 while geothermal heating is in use in 70 countries.〔 As of 2015, worldwide geothermal power capacity amounts to 12.8 gigawatts (GW), of which 28 percent or 3,548 megawatts are installed in the United States. International markets grew at an average annual rate of 5 percent over the last three years and global geothermal power capacity is expected to reach 14.5–17.6 GW by 2020.〔(【引用サイトリンク】title=The International Geothermal MarketAt a Glance – May 2015 )〕 Based on current geologic knowledge and technology, the Geothermal Energy Association (GEA) estimates that only 6.5 percent of total global potential has been tapped so far, while the IPCC reported geothermal power potential to be in the range of 35 GW to 2 TW.〔 Countries generating more than 15 percent of their electricity from geothermal sources include El Salvador, Kenya, the Philippines, Iceland and Costa Rica. Geothermal power is considered to be a sustainable, renewable source of energy because the heat extraction is small compared with the Earth's heat content.〔 The greenhouse gas emissions of geothermal electric stations are on average 45 grams of carbon dioxide per kilowatt-hour of electricity, or less than 5 percent of that of conventional coal-fired plants.〔Moomaw, W., P. Burgherr, G. Heath, M. Lenzen, J. Nyboer, A. Verbruggen, (2011: Annex II: Methodology. In IPCC: Special Report on Renewable Energy Sources and Climate Change Mitigation (ref. page 10) )〕 == History and development == In the 20th century, demand for electricity led to the consideration of geothermal power as a generating source. Prince Piero Ginori Conti tested the first geothermal power generator on 4 July 1904 in Larderello, Italy. It successfully lit four light bulbs.〔Tiwari, G. N.; Ghosal, M. K. ''Renewable Energy Resources: Basic Principles and Applications.'' Alpha Science Int'l Ltd., 2005 ISBN 1-84265-125-0〕 Later, in 1911, the world's first commercial geothermal power station was built there. Experimental generators were built in Beppu, Japan and the Geysers, California, in the 1920s, but Italy was the world's only industrial producer of geothermal electricity until 1958. In 1958, New Zealand became the second major industrial producer of geothermal electricity when its Wairakei station was commissioned. Wairakei was the first station to use flash steam technology.〔(IPENZ Engineering Heritage ). Ipenz.org.nz. Retrieved 13 December 2013.〕 In 1960, Pacific Gas and Electric began operation of the first successful geothermal electric power station in the United States at The Geysers in California.〔 The original turbine lasted for more than 30 years and produced 11 MW net power.〔 〕 The binary cycle power station was first demonstrated in 1967 in Russia and later introduced to the USA in 1981, following the 1970s energy crisis and significant changes in regulatory policies. This technology allows the use of much lower temperature resources than were previously recoverable. In 2006, a binary cycle station in Chena Hot Springs, Alaska, came on-line, producing electricity from a record low fluid temperature of 57°C (135°F).〔 Geothermal electric stations have until recently been built exclusively where high temperature geothermal resources are available near the surface. The development of binary cycle power plants and improvements in drilling and extraction technology may enable enhanced geothermal systems over a much greater geographical range.〔 Demonstration projects are operational in Landau-Pfalz, Germany, and Soultz-sous-Forêts, France, while an earlier effort in Basel, Switzerland was shut down after it triggered earthquakes. Other demonstration projects are under construction in Australia, the United Kingdom, and the United States of America.〔 〕 The thermal efficiency of geothermal electric stations is low, around 7–10%,〔Van der Sluis,L. ,Schavemaker P.: 'electrical power system essentials,John Wiley & sons, ltd. ISBN 978-0470-51027-8〕 because geothermal fluids are at a low temperature compared with steam from boilers. By the laws of thermodynamics this low temperature limits the efficiency of heat engines in extracting useful energy during the generation of electricity. Exhaust heat is wasted, unless it can be used directly and locally, for example in greenhouses, timber mills, and district heating. The efficiency of the system does not affect operational costs as it would for a coal or other fossil fuel plant, but it does factor into the viability of the station. In order to produce more energy than the pumps consume, electricity generation requires high temperature geothermal fields and specialized heat cycles. Because geothermal power does not rely on variable sources of energy, unlike, for example, wind or solar, its capacity factor can be quite large – up to 96% has been demonstrated.〔 〕 However the global average capacity factor was 74.5% in 2008, according to the IPCC.〔Goldstein, B., G. Hiriart, R. Bertani, C. Bromley, L. Gutiérrez-Negrín, E. Huenges, H. Muraoka, A. Ragnarsson, J. Tester, V. Zui (2011) ("Geothermal Energy" ). In ''IPCC Special Report on Renewable Energy Sources and Climate Change Mitigation'', Cambridge University Press, Cambridge, United Kingdom and New York, NY, USA Geothermal Energy. p. 404.〕 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「geothermal electricity」の詳細全文を読む スポンサード リンク
|